IPv4 Address Converter - Vultr.com

Apr 14, 2020 Solved: FE80::/10 addresses: What are they real - Cisco Hello John, the FE80::/10 are the link local addresses. It is correct that you don't see them in the routing table: as explained in a previous thread actually it is a single … FE80::1 is a Perfectly Valid IPv6 Default Gateway Address Aug 09, 2017 ipv6 - Why is fe80::/10 reserved for link local addresses I would presume that fe80::/64 is used because systems then run stateless address autoconfiguration (SLAAC) in that /64. Leaving the rest of the /10 available for …

Some solutions to the problem are: use an address of the form fe80:1::2/32, or use an address of the form fe80::1:2/64, where 1 is the Subnet ID and 2 is the Interface ID. Other solutions involve a hidden 'scope_id' and the use of special syntax ('%') to denote an interface.

IPv6 Address Lookup Tool | UltraTools The IPv6 Info tool provides WHOIS information, Autonomous System Number (ASN) information, expanded and compressed IP address information, and reverse lookup information for an IPv6 address. It also includes CIDR/netmask information for your IPv6 address. Note that due to the relatively small actual use of IPv6 addressing, ASN, WHOIS, and

If the IPv6 address you want to connect to starts with fe80::, we are talking about a link-local address. Access to this address is only possible within the same network or domain. Every device has a link-local address. Either assigned by an administrator or automatic. To get all the details of the network interfaces, you can use ifconfig.

If you assign the link-local address FE80::1 on each of its interfaces and if that link-local address is unique on each of those LAN segments, then this becomes the default gateway for the hosts on those LANs. Therefore, each host, no matter on which LAN, will see FE80::1 as the next-hop IPv6 address for the default route in its routing table. Auto-configured IPv6 address is known as Link-Local address. This address always starts with FE80. The first 16 bits of link-local address is always set to 1111 1110 1000 0000 (FE80). The next 48-bits are set to 0, thus: [Image: Link-Local Address] Link-local addresses are used for communication among IPv6 hosts on a link (broadcast segment) only. Apr 28, 2011 · Technically speaking, any address within the prefix fe80::/10 is considered a link-local address; this includes addresses beginning with fe80:: through febf::. (This last address prefix bumps up next to the fec0::/10 range assigned to the deprecated site-local address scope.)